From DIYinfo.org
|
This article is sponsored by
|
| Investment |
| Ceramic tiles should become an integral part of your home. Careful selection will enhance and protect your home and add to its capital value. Consider your tiling as a long term investment, even though it is an economical exercise. |
| Guarantee |
| Consider the value of a guaranteed quality product. At Beaumont Tiles all their tiles are guaranteed for 10 years. Some tiles at Beaumont's have extended guarantees to 30 years and one range has a cover of 100 years. |
| See more |
| Tiling fact sheets |
| Fact sheets for Beaumont Tiles |
| Fact sheets for Barrierflex |
| Fact sheets for ABA Primer |
| Visit |
| Beaumont Tiles Home Page |
| Find a Beaumont Tiles |
| Find a Tiler Near You |
[edit] Working out the quantities
This is very easy. Simply measure the room in metres, e.g. 3.64 x 2.43 then multiply the measurements = 8.85 sq.m. If the room is more complicated than a simple square or rectangle, just split the area up into rectangular areas, work them out in the same way and add the areas up at the end. Once again, it is most important to allow for cuts, breakages and spares so add 10% to your area for this purpose.
NOTE: Although mosaic sheets are "about" 30cm x 30cm, they do, in fact, vary a great amount, so firstly do not assume a sheet is 30cm x 30cm and secondly, do not compare the price of one sheet with another, as it won't work. Get back to a common measurement like square metres - then you can compare.
Mosaics, in general, can be applied to any level, rigid, clean surface, using the correct adhesives of course.
[edit] Wooden floors
Yes, you can lay tiles over timber floors by using Beaumont Tiles Barrierflex, ABA Ceramic Tile Underlay or Isoflex.
[edit] Cutting mosaics
Larger mosaics can be cut with the scriber/breaker as with wall tiles, but most cutting is done by nippers because of the generally smaller size of the tiles.
Beaumont Tiles also have tile cutting machines available for hire and these save time and effort in cutting.
[edit] Laying the tiles
Before starting, it is important to trial lay some tiles out to ensure as few small cuts as possible are used and to work out the easiest place to start.
Ensure that the tiles are straight by stretching a string from one end of the room to the other and follow the line, or use a straight edge. Make sure that there is plenty of adhesive on the back of the tile by lifting one now and then to check.
Ensure the tiles are pressed firmly into the adhesive by tapping them down with your wooden block.
Clean off any adhesive that may be on the mosaic and make sure your grout joints are reasonably clean. This will prevent blotchy grout. A small scrubbing brush is handy for this.
